CANCardX

[YogeshaYS]

Hi developer,Even i am using the labview and vector can card. I dont have the dll to establish the communication between Labview and vector can card.The vi's which u have attached has many bad sub vi's.can u send it again. Also pls send the required dlls for the same.It will be helpfull if send the procedure to do the same.my mail id is ***@lntemsys.comThanks in advance,YogeshMessage Edited by YogeshaYS on 06-04-2008 04:25 AM

[Sputnikrent]

Hi Yogesh, As explained by dhuff, there is a DLL provided by the manufacturer which you can use to interface with your device. Unfortunately dhuff posted this 2 years ago, so it's unlikely that he would be replying to this. I think the best bet would be for you to contact the manufacturer of your CAN card and see if they can provide a DLL or some driver VIs in order to communicate with it.Good luck!

[YogeshaYS]

Hi Rasheel, I have got the Vector CAN card.I have also downloaded the vetor driver VI's. But its not working, as it accepts the CAN messages signal by signal and not a message as whole.So, can u guid me to get a dll created in c or any other language that i can use.Thannx in advance,Yogesh

[Sputnikrent]

Hi Yogesha, Unfortunately I am not familiar with your card and have not worked with it before, so it'd be difficult for me to guide you in doing this. Have you tried contacting the manufacturer of the card to see what you can do?

[YogeshaYS]

Hi Rasheel, Yes i hav contacted the manfacturer i.e. VECTOR, i got a package of API's and it will accept signal by signal and not message.So, i am thinking of creating a dll from a c or c++ language.If u have ay dll rearding the same, pls send it.Thanks,Yogesh

[Sputnikrent]

Hi Yogesha, Unfortunately I do not have experience working with the CANCardX to do that.