CCP slave device with cRIO / ECU M&C Toolkit

[demo66]

Hi!
I'm triing to get started with the NI 9853 CAN module and the CompactRIO. I have already read simple CAN massages from a bus and wrote CAN massages.
Finally I want to make a CCP slave device with my cRIO. Is there any code, which already exists?
To my other question: Is the ECU M&C Toolkit interoperable with LV 8.5 and the cRIO 9012?
 
Thank you for your help!
 Message Edited by demo66 on 11-06-2007 11:08 AM

[demo66]

Thank you DirkW for your help!
I found on NI.com a PCMCIA-CAN device. Maybe I'll use this device with the NI ECU MC. Is the Toolkit interoperable with LV RT 8.5 and the PCMCIA device. Is it possible to use the Toolkit as MASTER on the one hand and as SLAVE on the other? If I use the Toolkit as slave, is it possible to use different A2L files?
 
 

[DirkW]

Unfortunately the ECU MC Toolkit only supports the master mode. There is currently no Slave mode support implemented.
DirkW

[Colin hughes]

But does the tool kit work with Labview 8.5?
Colin

[DirkW]

Not yet.
We plan to release in Q1, but you could install the LV 8.2 support and copy the necessary folders to your LV 8.5 version. A masscompile would compile them to LV 8.5 then.
 
DirkW

[Colin hughes]

Thanks Dirk
Colin